Top » Catalog » Airplane accessories » Tapes & seals » Seal » 2917 Log In  |  Create an Account  |  Bank account  |  Shipping & Returns  |  Conditions of Use  |  Contact Us  |  Cart Contents  |  Checkout   
Quick Find  
  

- [Advanced Search]

- Index of contents !!!

- All products
Categories  
Charter - EB 29 DR (DD)  
Information  
Shipping & Returns
Directions
Conditions of Use
Contact Us
Privacy Notice
Datenschutzerklärung
Transfer tape 15mm
[2917]
 € 23,95/roll 
(incl. 20% VAT)  

Special transfer tape as used for attaching Mylar strips, strong adhesive power, transparent, -30°C to +200°C.

price for one roll, deliverd only in whole rolls, 50m each

width 15 mm
 






Installation instructions for rudder gap profile band

Aileron gap profile band provides a smooth airflow between wings and ailerons or flaps as well as Stabilizer or vertical fin and their respective control surfaces. The tape decreases the drag produced by the gap between control surface and the adjacent structures. This in turn increases control surface efficiency and overall aircraft performance.

Check, whether your control surface have been sealed. Wind tunnel trials have shown an increase in performance by sealing Aileron and flap gaps. Considering certain types of aircraft control surface flutter can be caused by air flowing through the rudder gaps.

This problem can be solved by sealing foils. Attachment of only the rudder gap profile tape may not be sufficient.
 



Mounting the rudder gap profile tape

This tape (short: mylar band) is a high quality synthetic tape with a curved shape. It is attached on the top and bottom wing trailing edges so that the unfixed side of the tape meets the aileron or rudder at their thickest point. The tape is pressed onto the rudder by its shape and slides on it. Teflon spray, polish or mounting of teflon tape can be used to ease sliding of the tape and free movement of the rudder.

Before applying the adhesive film the profile band and the surface underneath must be free of grease or dirt.

As additional backup the profile band should be fixed with white PVC adhesive tape. Let the tape cover approx. 5mm of the wing with the rest on the profile band.(3).

Step by step procedure:

1. Clean and degrease the concerned surfaces on the band and wing with acetone or cellulose thinner.
2. Find out the optimum position for the band and mark it with a pencil.
3. Apply special adhesive film (12mm) along the previously marked line. You might consider using two strips when a large adhesive area is needed. Press the profile band firmly onto the adhesive film.
4. Carefully remove approximately 30-50cm of protective band from the adhesive film.
5. On the one end press the profile band firmly onto the adhesive strips while placing it under tension onto the rest of the adhesive strip from which the protective band has been removed beforehand.
6. Repeat the procedure step by step.
7. Firmly rub the band onto the adhesive strip with a soft cloth.
8. Apply the white PVC adhesive tape over the forward edge of the profile band.
9. Treat the area where the profile tape slides on the rudder regularly with either teflon spray or polish.

CAUTION!!!
Check free movement of the aileron/rudder. Make sure there is no blockage by the attached profile band. For safety reasons a qualified person should check the installation. The supplier of the tapes is not liable for any incorrect installation and will not assume any warrenty claims!


Quantity:
This product was added to our catalog on Sunday 22 October, 2017.
Customers who bought this product also purchased
Teflon Schutz/Gleitfolie
Teflon Schutz/Gleitfolie
Sealing tape standard 25mm
Sealing tape standard 25mm
Sealing tape premium 25mm (Nitto)
Sealing tape premium 25mm (Nitto)
Sealing tape premium 19mm (Nitto)
Sealing tape premium 19mm (Nitto)
Bowlus Maxi Tape 50mm
Bowlus Maxi Tape 50mm
Sealing tape 50mm white
Sealing tape 50mm white
Sealing tape standard 30mm
Sealing tape standard 30mm
Transfer tape 9mm
Transfer tape 9mm
Bowlus Maxi Tape 38mm
Bowlus Maxi Tape 38mm
Shopping Cart more 
0 items
Languages  
Deutsch Englisch Czech
Manufacturer Info  
Tesa
Other products
What's New? more 
Starterbatterie Hawker PC680 12V
Starterbatterie Hawker PC680 12V
€ 149,00/pcs
Specials more 
FLARM Reichweiten-Set + Splitter
FLARM Reichweiten-Set + Splitter
€ 147,91/pcs
€ 125,00/pcs
Hersteller  
  3M  ACK  AeroStar  AirAvionics - Butterfly  airbatt  AL-KO  ASA  Becker Avionic Systems  
 Beringer  BGS  Bosch  Boxwave  BWS Pirker & Storka  Castrol  Cleveland  Clouddancers  
 CTEK  Design 4 Pilots  deuter  DOLBA & DOLBA  Duracell  e-t-a  einszett  esa-systems  
 f.u.n.k.e. Avionics  FLARM  freytag&berndt  Gadringer-Gurte GmbH  Garmin  Hermesdorf  HPH Sailplanes  HR Richter  
 ICOM  IMI Gliding  Innotec  interieur  jetvision  Kannad  Klixon  Liqui Moly Aero  
 LX NAV  LX Navigation  MarS - ATL  MecaPlex  Mertens  MMM Software  Molykote  Mountain High  
 National Parachute  navITer  Nitto  NOVUS  Panasonic  Revell  Rogers Data  Sage Variometers  
 Shell  soaringXX  Sonnenschein  Spekon  Spot LLC  streckenflug.at  Tesa  Thermikwolke  
 Tost Flugzeuggerätebau  TQ  Trig  VDO  Walther Präzision  Winter  Wurmi